Operation Manual

www.honeywell.com/security
70 | Embedded Network Video Recorder User Guide
Click Save to save the new configuration. The NVR will return to the previous menu.
Configuring the Network
Click the Network icon in the Setting interface to open the Network configuration
interface.
Figure 3-27 Network Interface
Table 3-12 Network Configurations
Parameter Function
IP Version Select either IPv4 or IPv6. Both formats are supported.
MAC Address Each NVR gets a unique MAC address. You can use the MAC
address to connect to the NVR in the LAN. The MAC address
is not configurable; it is read-only.
IP Address Use the Up/Down arrows (
/) to select an IP address, or
use the keyboard to enter an IP address. Then configure the
corresponding subnet mask for the default gateway.
Subnet Prefix Select from 0 to 128. Used to mark a specified network MAC
address.
Default Gateway Enter the default gateway.
Note The system needs to check the validity of all IPv6
addresses. The IP address and the default gateway
must be in the same IP section. The specified length of
the subnet prefix must have the same string.
IPv4 IPv6