Operation Manual

Configuration | 65
800-21261V3 - A - 05/2016
Region 1. Select a motion detection type.
2. Click Set. The Motion Detection Set configuration
interface appears.
3. Select the event detection area by left-clicking and
dragging the mouse.
There are 396 (PAL) or 330 (NTSC) small zones.
Green: Indicates the current cursor position.
Grey: Indicates the event detection zone.
Black: Indicates a disarmed zone.
4. Select a Sensitivity, from 1 to 100. The higher the number,
the higher the sensitivity.
5. Click Save to save the configurations. Click Esc to exit the
setup without saving the changes.
Record Channel The system automatically starts recording selected channels
when a motion detection alarm occurs.
Note You need to set the motion detection recording period.
Go to Storage
Schedule to configure the current channel
for scheduled recording. Refer to the User Guide for more
information about Configuring Recording Schedule
Storage Settings.
Delay The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.
Alarm Out Select the device output port, 1 or 2. Select the corresponding
port(s) so the system can activate the corresponding alarm
devices when an alarm occurs.
Latch The system can delay the alarm output for a specified time
after an alarm ends. The value ranges from 1s to 300s.
Table 3-14 WEB - Motion Detection Configurations
Configuration Description