Operation Manual
NVR Configurations | 103
800-18160 - A - 06/2014
Note You must click Save after configuring the settings to save them.
Note In the Detection interface, the copy-and-paste function is only valid for the same
type of event detection. You can not copy a channel setup in video loss mode to
camera masking mode.
TIP! You can enable a preset, tour, or pattern activation for when video loss occurs.
Show message Configure the system to automatically pop up a message in
the local view screen when an alarm occurs.
Alarm upload Click to enable the system to upload the alarm signal to the
network (including an alarm center and the web client). The
system uploads only the alarm channel status.
Go to the Web operation, and then go to the Alarm interface
to set the alarm event and alarm operation. See Enabling and
Disabling Alarms on page 157 and Configuring Alarms on
page 184.
Send email The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
Menu
Setting NetworkEmail to configure the email
settings. See Configuring the Email Settings on page 84.
Record channel Select a recording channel. See How to Record on page 94 for
more about recording.
PTZ activation When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected. The PTZ activation
lasts the anti-dither period.
See Configuring PTZ Activation on page 95.
Record delay The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.
Tour Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. Go to Configuring Display Settings
on page 110 for tour interval setup.
Note Tours setup here have higher priority than tours setup
in the Display interface. If there is no alarm, the system
implements the tour setup in the Display interface.
Snapshot Click to enable the Snapshot function. A snapshot will be
taken when an event occurs.
Table 3-24 Video Loss Detection Configurations
Configuration Description