Operation Manual

Web Operation | 185
800-18160 - A - 06/2014
Figure 5-44 Local Alarm Configuration Interface
Table 5-20 Local Alarm Configurations
Configuration Description
Enable Click to enable local alarms. Select a channel from the
drop-down list.
Period Define a period during which local alarms are active.
1. Click Set. The Set configuration interface appears.
2. Select a time period.
Note You can configure up to 6 periods within one day.
3. Select a date. If you do not select a date, the current setup
will apply to today only.
Note You can select All Week if you want these settings to
apply to the whole week.
4. Click OK, then click Save.
Type Select from NO or NC.
Record Channel When an alarm occurs, the system automatically records
motion detection channels.
Note You need to set the motion detection recording period.
Go to Storage
Schedule to configure the current channel
for scheduled recording. See Configuring Local Storage for
Schedules on page 192.
Delay The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.