Operation Manual

NVR Configurations | 67

800-18160 - A - 06/2014

Figure 3-25 Schedule Interface

Click the corresponding box to enable each function. Click OK to save the settings and

return to the previous menu.

Table 3-10 Schedule Configurations

Parameter Function

Channel Select a channel number. Select All for all channels.

Week day Select a day of the week, or All.

Pre-record The NVR has a buffer that allows it to "record" video that happens

before an event occurs. Select from 1 to 30 seconds, depending on

the bit stream.

Redundancy You can configure the NVR to backup recorded files onto two

different HDDs. Click to enable.

Note Before you can enable this function, you must configure at

least one HDD as redundant. Go to Main

Advanced HDD Management).

Note This function is not available if there is only one HDD.

Snapshot Click to enable the Snapshot function, which takes a snapshot

when an alarm occurs.

Record type Select from: Regular, Motion Detection (MD), Alarm, MD&Alarm.

Holiday Click to enable the holiday settings you configured in the General

interface. See Configuring the General Settings on page 60.