Operation Manual

www.honeywell.com/security
108 | Performance Series Full PoE Network Video Recorder User Guide
Configuring System Event Settings
There are two types of system events: HDD errors (no disk, disk error, no space) and network
errors (no connection, IP conflict, MAC conflict).
Configuring HDD Event Settings
To configure HDD event settings
1. Go to Main Menu > SETTING > EVENT > ABNORMALITY > HDD.
Figure 8-8 HDD Abnormality Configuration Tab
2. On the HDD tab, in the Event Type box, select the event type that you want to configure
settings for: No Disk, Disk Error, No Space.
3. Select the Enable check box to enable HDD error detection.
4. Select the actions that you want the system to initiate when the selected event occurs:
•Alarm Out Select the alarm output(s) ( 1 or 2 ) that you want to activate. In the Latch
box, specify the amount of time (1–300 s) to delay the alarm output
signal after the HDD event is triggered.
•Show Message Select the check box to enable a pop-up message on your local host PC.
•Alarm Upload Select the check box to enable the system to upload an alarm signal to
the network (including to an alarm center and/or web client).