Operation Manual
www.honeywell.com/security
112 | Performance Series Full PoE Network Video Recorder User Guide
To set up alarm input event actions
1. On the Local Alarm tab, in the Anti-Dither box, specify the amount of time (5–600 s) to
delay the system’s reaction to subsequent triggered alarms after the first alarm is
triggered. During the anti-dither time, if the system detects another alarm, the system will
not be initiate actions for that alarm.
2. Select the actions that you want the system to initiate when an alarm input is triggered
occurs:
3. Click Apply to save your settings.
4. To copy the alarm event settings to additional channels, click Copy, select the channels to
which you want to copy the settings, and then click OK.
Configuring No Signal Alarm Events
Go to Main Menu > SETTING > EVENT > ALARM > No Signal.
•Alarm Out
Select the check box to activate the selected alarm output(s) (
1
,
2
, or
3
).
In the
Latch
box, specify the amount of time (1–300 s) to delay the alarm
output signal after an alarm event is triggered.
•Show Message
Select the check box to enable a pop-up message on your local host PC.
•Alarm Upload
Select the check box to enable the system to upload an alarm signal to
the network (including to an alarm center and/or web client).
•Send Email
Select the check box to enable the system to send an email notification.
If the
Snapshot
function is enabled, an image can be attached to the
email. To set up Email settings, see
Configuring Email Settings
on page
93.
• Record Channel
Select the channel(s) that you want to record. In the
Delay
box, specify
the amount of time (1–300 s) to delay recording after an alarm event is
triggered.
Note You also need to set the alarm recording period. Go to
Storage > Schedule to configure the current channel for
scheduled recording. See Configuring the Video Recording
Schedule on page 63.
• PTZ Activation
Select the check box to activate PTZ functions, and then click
Select
. In
the
PTZ Activation
window, for each PTZ camera, select the preset,
tour, or pattern that you want to be called when an alarm event occurs,
and then click
OK
.
•Tour
Select the check box to enable a tour of the selected channels.
•Snapshot
Select the check box to take a snaphot of selected channels.
• Buzzer
Select the check box to activate a buzzer noise at the NVR.