Operation Manual

www.honeywell.com/security
62 | Performance Series Full Poe Embedded NVR Remote User Guide
Configuring Switch Settings
You can change the IP Address, Subnet Mask, and Default Gateway for setting the PoE switch
settings.
1. Click Switch under Network to open the Switch interface.
Figure 3-33 Switch Configuration Interface
2. Configure the following settings:
3. Click Apply to save your settings.
Configuring Event Settings
Configuring Video Detection
Motion Detection Configurations
You can configure the system to generate a motion detection alarm when the minimum amount
of motion (as defined by you) is detected in the video.
Click Detect under EVENT to open the Motion Detect configuration interface.
Table 3-13 Switch Configurations
Configuration Description
IP Address Enter a new IP address.
Subnet Mask Enter a new subnet mask.
Default Gateway Enter a new default gateway.