Operation Manual

www.honeywell.com/security
66 | Performance Series Full Poe Embedded NVR Remote User Guide
Video Loss Detection Configurations
You can configure the system to generate a video loss alarm when the minimum amount of
video loss (as defined by you) is detected in the video.
PTZ Activation When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected.
1. Click Setup to open the PTZ Activation configuration
interface.
2. Select a preset, tour, or pattern from the drop-down menu.
3. Click Save.
Tour Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. Refer to the User Guide for more
about tour interval setup. On the Display Settings tab, when
there are two tours enabled by default, you can configure the
system so an alarm triggers the system to enable the alarm
tours you configured here. If there is no alarm, then the system
uses the tour setup that was configured in the Display
interface.
Snapshot Click to enable the Snapshot function. Channel snapshots
are taken according to the schedule you configure. Alarm
snapshots are taken when an alarm occurs.
Show Message Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
Send Email The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to
Network
Email to configure the email settings. Refer to the
User Guide for more information.
Alarm Upload Enable this function, and when a motion event is detected, an
alarm message is uploaded to the NVR.
Buzzer Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.
Table 3-14 WEB - Motion Detection Configurations
Configuration Description