Operation Manual

Configuration | 73
800-21261V3 - A - 05/2016
Configuring Storage
Configuring Storage Schedules
You can add or remove schedules for recording.
There are four recording modes: General (auto), Motion Detect, Alarm, and MD&Alarm. You
can configure up to six periods per day.
1. Click Schedule under STORAGE to open the Schedule configuration interface.
Table 3-16 Configuring for Abnormalities
Configuration Description
Event Type Select from No Disk, Disk Error, Disk No Space, Net
Disconnection, IP Conflict, and MAC Conflict.
Less Than: (For No Space configuration only) Configure the
minimum percentage of free space on the disk. An alarm lets
you know when the disk capacity is low. You need to click to
enable this function.
Enable Click to enable this function.
Alarm Out Select the device output port, 1 or 2. Select the corresponding
port(s) so the system can activate the corresponding alarm
devices when an alarm occurs.
Latch The system can delay the alarm output for a specified time
after an alarm ends. The value ranges from 1s to 300s.
Show Message Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
Send Email The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
Menu
SettingNetworkEmail to configure the email
settings. Refer to the User Guide for more information.
Buzzer Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.