Operation Manual

Configuration | 79
800-21261V3 - A - 05/2016
Figure 3-47 Date & Time Configuration Interface
Holiday Settings
1. Click the Holiday Setup tab in the GENERAL settings configuration interface to open the
Holiday Setup configuration interface.
Table 3-21 Date & Time Configurations
Configuration Description
Date Format Select the date format from the drop-down list.
Time Format Select from either 24 hour or 12 hour.
Date Separator Select from a period (.), a hyphen (-), or a slash (/).
System Time Set the NVR’s time. You have to Save to activate this setting.
Sync PC Click to synchronize your NVR’s time with your PC’s time.
Time Zone Select a Time Zone for the NVR.
DST Click to enable Daylight Saving Time (DST). Click to select a
type, either Date or Week. Then configure a date and time
when DST begins and ends.
NTP Click to enable the NTP server.
NTP Server Enter the NTP time server address.
Port Enter the NTP time server port.
Upgrade
Period/Interval
Configure the synchronization period between the NVR and
the NTP time server.