Operation Manual

www.honeywell.com/security
98 | Performance Series Full Poe Embedded NVR Remote User Guide
Figure 5-1 Alarm Configuration Interface
Table 5-1 Alarm Configurations
Configuration Type Configuration Description
Alarm Type
Motion Detect Click to enable Motion Detection. The
system will then trigger an alarm when motion
is detected under the specified
circumstances.
Video Masking Click to enable Video Masking. The system
triggers an alarm when camera masking
occurs.
Video Loss Click to enable Video Loss. The system then
an alarm when video loss occurs.
IPC External
Alarm
Click to enable the camera’s External Alarm,
the On/Off signal from the network camera. It
activates the NVR to locally activate.
External Alarm An alarm that is connected to the NVR, such
as an infrared detector.
Disk Error Click to enable the Disk Error alarm. The
system triggers an alarm when a disk error
occurs.
Disk Full Click to enable the Disk Full alarm. The
system triggers an alarm when the disk is full.
No Signal Click to enable the No Signal alarm. The
system triggers an alarm when the network
camera and the NVR are disconnected.
Operation Prompt Click to enable the Prompt. Then the system
automatically pops up an alarm icon on the
Alarm button on the Main interface when
there is an alarm.
Alarm Sound
Play Alarm
Sound
Click to enable the Alarm Sound. Then the
system triggers an alarm sound when an
alarm occurs. You can choose the sound.
Sound Path Select the sound file.