Operation Manual

Configuration | 51
800-21261V3 - A - 05/2016
Configuring FTP
FTP allows you to configure settings for remote storage. Before you can enable FTP, you must
download or buy an FTP service tool. Refer to the Network Settings chapter of your User Guide
for more information.
Click FTP under NETWORK to open the FTP configuration interface.
Figure 3-16 FTP Configuration Interface
Interval The interval for sending ranges from 0 to 3600 seconds. 0
means that there is no interval.
Note The system will not send an email immediately when
the alarm occurs. When an alarm, motion detection, or
video abnormality triggers an email, the system sends
out the email according to the interval that is specified
here. This function is very useful when there are too
many emails activated by events, which might result in
an overload for the email server.
Health enable Click to enable the email health check. The NVR sends a test
email to check the network connection.
After enabling Health Enable, you can configure how
frequently the NVR sends out emails to test the network
connection.
Update Period (Interval) Allows the system to send out a test email to check the
connection.
Check the box to enable this function, and then set the
corresponding interval for the system to send out regular test
emails.
Test Click Test to send a test email. A popup message appears to
indicate the state of the network connection.
Table 3-10 Email Configurations
Parameter Description