Operation Manual

www.honeywell.com/security
80 | Performance Series Full PoE Network Video Recorder User Guide
Note If the NVR fails to retrieve the configuration information for your selected
camera/channel, then you should navigate to a different window (such as
Snapshot or Overlay), then navigate back to the Encode window.
3. Configure the following settings for the primary stream and secondary stream:
4. Click Apply to save your settings.
5. To copy the settings to one or more additional cameras, follow these steps:
a. Click Copy.
b. Click the specific camera(s) to which you want to copy the settings, or click All to
select all the cameras, and then click OK.
6. If you want to save your settings and exit the SETTING menu, click OK.
Configuring Snapshot Settings
To configure a camera’s snapshot settings
1. In the SETTING field in the Main Menu, go to REMOTE> Video&Audio > Snapshot.
•Code Stream
Type
Set the primary stream type as Regular, MD (Motion Detection), or
Alarm. The secondary stream type is not configurable.
• Compression This setting is not configurable.
•Resolution Set the primary stream to one of the following resolutions: 1080P,
720P, 960H, D1, HD1, 2CIF, or CIF. Set the secondary stream to
one of the following resolutions: D1, CIF, or QCIF.
Note NVRs can detect a connected 1080p or 720p IP camera's
resolution as 1080P or 720P automatically. Manually set
960H or lower resolution for analog cameras and for 1080p
IP cameras switched to SD mode.
•Frame Rate Select a value between 1 and 30 (NTSC) or 1 and 25 (PAL).
• Bit Rate Type Set to CBR (constant bit rate) or VBR (variable bit rate).
•Quality If the bit rate type is set to VBR, select a value between 1 and 6.
Note If your device is connected to the NVR through ONVIF, then
you can not select VBR. If your device is connected to the
NVR through a private protocol, then you can select either
CBR or VBR.
• I Frame Interval Set to 1 S or 2 S.
•Bit Rate Set to a value within the Reference Bit Rate range. To enter a bit
rate that does not appear on the list, click Customized.
• Audio/Video Select or clear the check boxes to enable or disable audio and/or
video.