Operation Manual

www.honeywell.com/security
44 | Performance Series Full Poe Embedded NVR Remote User Guide
Figure 3-10 CDMA/GPRS Configuration Interface
Table 3-7 CDMA/GPRS Configurations
Configuration Description
WLAN Type Select a 3G network type to distinguish this 3G module from
different ISPs. Choose from WCDMA, CDMA1x, for example.
APN & Dial No. APN and the Dial No. are important PPPoE parameters. The
APN (Access Point Name) and the Dial No. are automatically
received by the NVR after connecting to a 3G module.
Dial/SMS Activate Enable/disable Dial/SMS Activate. When enabled, if the user
sends an "ON" message by phone to the NVR, then the NVR
dials and connects with CDMA/GPRS. If the user sends an
"OFF" message by phone to the NVR, then the NVR breaks the
link with CDMA/GPRS.
AUTH Authorization. Choose from PAP, CHAP, or NO_AUTH.
Username / Password Enter a username and password for logging onto the 3G
network.
Pulse Interval Configure a time for ending the 3G connection after you close
the extra stream monitor. For example, if you select 60 here,
the NVR ends the 3G connection 60 seconds after you close
the extra stream monitor.