Operation Manual

www.honeywell.com/security
82 | Performance Series Full Poe Embedded NVR Remote User Guide
RS232 Configurations
1. Click RS232 under SETTING to open the RS232 configuration interface.
Figure 3-51 WEB - RS232 Configuration Interface
2. Make your selections, then click Save.
Configuring PTZ Settings
Before configuring PTZ, please ensure the following:
• The PTZ and decoder are connected correctly, and that the decoder address setup is
correct.
• That the correct decoder line is connected to the correct NVR line (A to A; B to B).
Window Split Set the window mode and channel group. Depending on your
NVR, it can support up to a 1/4/8/9/16-window split.
Channel Group Add channels to a channel group, and when the NVR starts a
tour, the tour starts only on the selected channels for the
group.
Motion Tour/Alarm Tour
Type
Set the Motion Detection Tour and Alarm Detection Tour
window modes. The NVR can support 1/8 window.
Table 3-23 Display Tour Settings
Setting Description
Table 3-24 RS232 Web Configurations
Setting Description
Function Select the corresponding dome Protocol. The default is
Console.
Baud Rate Select the Baud Rate. The default is 115200.
Data Bit Select from 5 to 8. The default is 8.
Stop Bit Choose either 1 or 2. The default is 1.
Parity Select from None, Odd, Even, Space, or Mark. The default is
None.