Operation Manual

Configuring Network Settings | 97
800-21090V2 - A - 03/2016
3. Configure the following settings:
4. Click Apply to save your settings.
5. If you want to save your settings and exit the SETTING menu, click OK.
Configuring Multicast Settings
Multicast allows for simultaneous real-time monitoring of live video from the NVR at multiple
remote locations over the network.
To configure multicast settings
1. In the SETTING field in the Main Menu, go to NETWORK > Multicast.
Figure 7-12 Network Multicast Settings Window
2. On the Multicast page, select the Enable check box to enable multicast.
3. In the IP Address box, enter a multicast IP address. The address must be valid for
multicasting and should be in the range 224.0.0.0 to 239.255.255.255 for IPv4 or have the
prefix ff00::/8. An address in the range 239.252.0.0 to 239.255.255.255 is recommended.
4. In the Port box, enter a multicast port number or use the default setting (36666).
5. Click Apply to save your settings.
•SNMP Version Select the check boxes of the SNMP version(s) that you are
using.
• SNMP Port The default setting is 161.
• Read Community The default setting is public.
• Write Community The default setting is private.
• Trap Access Enter the IP address of the computer running SNMP software.
• Trap Port The default setting is 162.