Spec Sheet

60 / 80 kW Installation Layout
Drawing A0000293264 Rev B (1 of 2)
4 3 2 1 4 3 1
A B
A B
1041.4 [41.00]
DOOR WIDTH TYP
960 [37.8]
CG (SEE NOTE 5)
2481 [97.7]
OVERALL LENGTH
109 [4.3]
1241 [48.9]
OVERALL
HEIGHT
63.5 [2.5]
LIFTING EYE (4X)
47 TYP [1.8]
2357 [92.8] TYP
964 [38.0]
OVERALL WIDTH
68 TYP [2.7]
350 [13.8]
SERVICE ITEM 4.5L
OIL FILL CAP LEFT SIDE
OIL DIP STICK LEFT SIDE
OIL FILTER LEFT SIDE
OIL DRAIN HOSE LEFT SIDE
RADIATOR DRAIN HOSE RIGHT SIDE
COOLANT RECOVERY BOTTLE RIGHT SIDE
RADIATOR FILL CAP ROOF TOP
AIR CLEANER ELEMENT EITHER SIDE
SPARK PLUGS LEFT SIDE
MUFFLER SEE NOTE 11
FAN BELT EITHER SIDE
BATTERY LEFT SIDE
WEIGHT DATA
ENGINE/KW
ENCLOSURE
MATERIAL
WEIGHT
GENSET ONLY
KG [LBS]
WEIGHT
SHIPPING SKID
KG [LBS]
SHIPPING WEIGHT
KG [LBS]
4.5L/60KW AL 857 (1890) 79 [175] 936 (2064) 4.5L/80KW AL 903 (1990) 79 [175] 983 (2165]
TITLE
INSTALL G4.5L G26 60-80KW C3
ISSUE DATE:
SIZE CAGE NO DWG NO
A0000293264
REV
B
N/A
B
SCALE
0.035
WT-KG SHEET
1 of 2
GENERAC POWER SYSTEMS OWNS THE COPYRIGHT OF THIS DRAWING WHICH IS SUPPLIED IN CONFIDENCE AND MUST NOT BE USED FOR ANY PURPOSE OTHER THAN FOR WHICH IT IS SUPPLIED WITHOUT THE EXPRESS WRITTEN CONSENT OF GENERAC POWER SYSTEMS. c GENERAC POWER SYSTEMS 2013
ELECTRONICALLY APPROVED
INSIDE WINDCHILL
DRAWING CREATED FROM PRO/ENGINEER 3D FILE. ECO MODIFICATION TO BE APPLIED TO SOLID MODEL ONLY.
SH
1/2
REV
B
WINDCHILL VERSION
B.3
NOTES:
1. MINIMUM RECOMMENDED CONCRETE PAD SIZE: (6" LARGER PER SIDE THAN GENERATOR) 1269 (50") WIDE 2786 (110") LONG. REFERENCE INSTALLATION GUIDE SUPPLIED WITH UNIT FOR CONCRETE PAD GUIDELINES. 2. ALLOW SUFFICIENT ROOM ON ALL SIDES OF THE GENERATOR FOR MAINTENANCE AND SERVICING. THIS UNIT MUST BE INSTALLED IN ACCORDANCE WITH CURRENT APPLICABLE NFPA 37 AND NFPA 70 STANDARDS AS WELL AS ANY OTHER FEDERAL, STATE, AND LOCAL CODES. 3. CONTROL PANEL / CIRCUIT BREAKER INFORMATION: - SEE SPECIFICATION SHEET OR OWNERS MANUAL - ACCESSIBLE THROUGH CUSTOMER ACCESS ASSEMBLY ON REAR OF GENERATOR. 4. INSIDE STUB-UP AREA FOR AC LOAD LEAD CONDUIT CONNECTION, NEUTRAL CONNECTION, BATTERY CHARGER 120 VOLT AC (.5 AMP MAX) CONNECTION AND ACCESS TO TRANSFER SWITCH CONTROL WIRES. REMOVE REAR COVER FOR ACCESS. 5. CENTER OF GRAVITY AND WEIGHT MAY CHANGE DUE TO UNIT OPTIONS. 6. BOTTOM OF GENERATOR SET MUST BE ENCLOSED TO PREVENT PEST INTRUSION AND RECIRCULATION OF DISCHARGE AIR AND/OR IMPROPER COOLING AIR FLOW. 7. REFERENCE OWNERS MANUAL FOR LIFTING WARNINGS. 8. MOUNTING BOLTS OR STUDS TO MOUNTING SURFACE SHALL BE 5/8-11 GRADE 5 (USE STANDARD SAE TORQUE SPECS) 9. MUST ALLOW FREE FLOW OF INTAKE AIR, DISCHARGE AIR AND EXHAUST. SEE SPEC SHEET FOR MINIMUM AIR FLOW AND MAXIMUM RESTRICTION REQUIREMENTS. 10. GENERATOR MUST BE INSTALLED SUCH THAT FRESH COOLING AIR IS AVAILABLE AND THAT DISCHARGE AIR FROM RADIATOR IS NOT RECIRCULATED. 11. REMOVE FRONT END PANEL TO ACCESS EXHAUST MUFFLER. ACCESS AVAILABLE THROUGH DOORS TO FAN BELT.
EXHAUST MUFFLER
ENCLOSED WITHIN
GENERATOR ENCLOSURE
SEE NOTES 9, 10 & 11
DIMENSIONS: MM [INCH]
RADIATOR/EXHAUST DISCHARGE AIR
RADIATOR/EXHAUST DISCHARGE AIR (BOTH SIDES)
AIR INTAKE (BOTH SIDES)
LEFT VIEW
CIRCUIT BREAKER
SEE NOTE 3
REFERENCE OWNERS MANUAL FOR PERIODIC REPLACEMENT PART LISTINGS.
REAR ENCLOSURE COVER PANEL SEE NOTE 4
CUSTOMER ACCESS ASSEMBLY, CONTROL PANEL ACCESS BATTERY CHARGER LOCATED WITHIN SEE NOTE 3 & 4
REAR VIEW
VICE ACTION LATCH ONE PER DOOR ONE LIFT OFF DOOR PER SIDE OF GENERATOR
RIGHT VIEW
FUEL LINE CONNECTION 1-1/4" NPT FEMALE TEE THROUGH BASE FRAME OPENING
RADIATOR DRAIN
TOP VIEW
BATTERY 12V
GRP 27F
NEGATIVE GROUND
P/N G058665
REMOVE COVER FOR
ACCESS TO RADIATOR
FILL CAP
OIL DRAIN