Install Instructions

PLUMBING

STEP ONE: Connect the Cold Water Supply

Do not use hot water supply. Cold water is required

to cool boiling water to safe draining temperatures.

Insert one end of the water line into the water lter

or reverse osmosis kit. Use the 1/4-inch plastic

water line provided or a 1/4-inch copper water line.

Apply a modest pull to ensure a tight t.

Use clamps or ties to secure the water lter in a

location that allows for removing and replacing it in

the future. Honeywell recommends changing the

water lter or RO canisters 1 & 2 annually, or as

needed based on water conditions.

Install the provided backow preventer, as required

by code. See “Appendix F: Reverse Osmosis

Filter” if using the Reverse Osmosis Filter.

Cut the water line so it is long enough to reach

from the water lter to the supply tting on the

bottom of the TrueSTEAM.

Insert the water line into the TrueSTEAM

supply tting.

Note: Failure to check for a tight t with plastic water

line could result in the line coming loose in the future.

Apply modest pull to ensure water line is properly

seated and secure.

STEP TWO: Tap into a Water Line

• Consult local codes for proper plumbing.

• Use the saddle valve provided or a T-tting and

manual shutoff valve to tap into a cold water

line.

• Refer to the literature included with the valve

you chose and the local plumbing codes. Use

proper technique for the valve.

Saddle Valve

T-fitting

Water Supply

Line

Manual Shutoff

Valve

M29605

Water Supply and Drain Connections

MCR32911

BEST

PRACTICE

Use a manual shutoff valve when tapping into a water line.

TrueSTEAM Humidication System 69-2285—05