Install Instructions

PLUMBING

STEP THREE: Connect TrueSTEAM to the Cold Water Pipe

Connect one end of the remaining length of water

line to the backow preventer. Apply a modest pull

to ensure a tight t. See “Reverse Osmosis Filter” on

page 23 if using the Reverse Osmosis Filter.

Connect the other end of this line to the saddle valve

or T-tting and manual shutoff valve.

STEP FOUR: Connect to the Water Drain

• Consult and follow local plumbing codes for drain

pipe size and maximum temperature requirement.

• The ideal installation is directly to the main oor

drain using the rubber hose provided.

• If direct oor drain access is not available, see

“Other Plumbing Options” on page 15.

Connect the 1/2-inch drain hose provided to the drain

tting on the bottom of the TrueSTEAM.

Use the hose clamp provided to secure the drain hose

to the barbed tting.

Route the drain hose to the oor drain. The hose must

have a continuous downward slope.

Direct the hose outlet into the oor drain. Secure

the hose to reduce the risk of hot water pooling

or splashing.

MCR32901

M29607

Before proceeding to Wiring:

I have conrmed minimum required circuit capacity

I have connected the water supply using cold water

I have installed the drain connection

CAUTION: Scalding Hazard.

During operation, hot water may exit drain and can cause burns from scalding.

Make sure the hose is securely connected to the drain.

TrueSTEAM Humidication System 69-2285—05 15