User Guide
EVERYDAY
OPERATION
The two buttons are used when starting the Steam Humidier and to manually drain the tank.
Drain Button: Press and hold to drain water from the
Steam Humidier tank. See “How do I clean the tank?”
on page 16.
When the Draining light is blinking, the Steam
Humidier is actively ushing water during a manual
drain.
Go Button: Press to start or reset the Steam
Humidier when the Humidifying light is blinking.
Pressing and holding Go also clears the blinking
Service light and stops water draining from the tank.
Drain and Go Button: Pressing and holding both the
Drain and Go buttons in at the same time will interrupt
the water cooling cycle and immediately drain
the tank.
IMPORTANT: Pressing and holding the Drain and Go
buttons together—when the Draining light is already
on—causes the Steam Humidier to empty the tank,
regardless of water temperature. Make sure the drain
outlet can handle up to 212ºF (100ºC), or wait at least
45 minutes to allow the water to cool before using
this feature.
CAUTION: Scalding Hazard.
Initial temperature of the drain water may be above 140°F (60°C) and can cause scalding injury.
Make sure the drain outlet is not exposed, and use caution when pressing the Drain button.
When will I press the Drain and Go buttons?
M29628A
Steam Humidication System 69-2286EF—05
14