user manual

– 19 –
SECURING THE PREMISES
SECURING THE PREMISESSECURING THE PREMISES
SECURING THE PREMISES
Arming the System
Arming in Stay Mode
Use this mode when you are staying home, but expect someone to use the entrance door
later. Close all protected perimeter windows and doors before arming. The green Ready
indicator on the control should be lit if the system is ready to be armed. When armed in
STAY mode, the system will sound an alarm if a protected door or window is opened, but you
may otherwise move freely throughout the premises. Late arrivals can enter through the
designated entrance door without causing an alarm, but they must disarm the system within
the entry delay period or an alarm will occur.
If Quick Arm was programmed by the installer,
you do not need to enter the security code to arm the system. The security code must always
be used to disarm the system, however.
The Babysitter Code and Installer Code cannot disarm the system unless it was used to arm
the system. In addition, if the system is armed by pressing via Quick-Arming, neither the
Babysitter Code nor Installer Code can disarm the system.
Ready To Arm
5000-100-006-V1
Arm Away
Delay
Phone
More
Automation
Message
Zones
Arm Stay
72
10:18 AM June 8, 2010
1. Select the Arm Stay icon, the system
beeps once and displays a keypad.
Ready To Arm
Arm the system in Stay mode
Enter Code:
Cancel
231
564
0
897
Clear
5000-100-137-V0
2. Enter a valid User Code.
OR
If Quick Arm has been enabled, select the
“Quick Arm” icon.
The system beeps three times and
announces “Armed Stay Exit Now”. The
exit delay screen is displayed. If
programmed the display counts down the
time remaining in the exit delay.
Note: If a valid user code is not entered or the
Confirm icon has not been selected within
10 seconds, the system returns to the
“home” screen and it will not be armed.