User's Manual
Table Of Contents
- Warnings and Safeguards
- Contents
- Introduction
- Installation
- Setup
- Operation
- Remote Software
- Play Controls
- Performing a Basic Search
- Adjust the Brightness of an Image
- Zooming in on an Image
- Zooming in on a Portion of an Image
- Printing an Image
- Save Clip
- Status Search
- PTZ Overview
- Web Viewer Overview
- Alarm Monitor
- Digital Verifier Overview
- FVMS (option) Overview
- Appendix
- Button Index
- DVR FAQ
- Troubleshooting
- Specifications (HRDP H.264)
- Specifications (HRDPX H.264)
Setup
______________________________________________________________________________________________
32
System Configuration Continued
Use DST – After completing the Time Zone setup, highlight USE DST and
press ENTER to turn Daylight Saving Time ON / OFF.
NTP Type – Highlight NTP (Network Time Protocol) and press ENTER to
SYNC the DVR with the Network Time.
Keypad Beep – ON / OFF [Enables / Disables Audible keypad touch
confirmation].
Auto Log Off – OFF or 1-10 Minutes [This feature will close the Configuration
Menu after XX minutes of inactivity. This is a security feature.]
S/W Upgrade – Start firmware upgrade from selected media (USB or
CD/DVD)
Upgrade Firmware
1. Press SETUP on the front panel or remote control.
or
Click MENU on the hover menu and select SETUP.
2. Select SYSTEM > SYSTEM CONFIGURATION.
3. Click S/W UPGRADE to open the UPGRADE FIRMWARE window.
4. Insert the CD/DVD or USB device.
5. Select the media type (DVD/CD-ROM / USB HDD/STICK).
6. Click SCAN.
7. Click OK to start the upgrade.