User Guide
Table Of Contents
- 1. Safety
- 2. Modbus - general info
- 3. Modbus technical data
- 4. Modbus installation
- 5. Programming
- 5.2.1 Ethernet common settings (M5.8.1)
- 5.2.2 Modbus TCP settings (M5.8.2)
- 5.3.1 Modbus RTU Parameters
- 5.3.2 Modbus RTU monitoring values
- 5.4.1 Ethernet common settings
- 5.4.2 Modbus TCP settings
- 5.4.2.1 Common settings
- 5.4.3 Modbus TCP monitoring values
- 5.4.3.1 Connection 1
- 5.4.3.2 Connection 2
- 6.3.1 Coil registers
- 6.3.2 Input discrete registers
- 6.3.3 Holding and input registers
- 6.3.3.1 Drive Application ID’s
- 6.3.3.2 FB Process data IN
- 6.3.3.3 FB Process data OUT
- 6.3.3.4 ID map
- 6.3.3.5 Operation day counter
- 6.3.3.6 Resettable operation day counter
- 6.3.3.7 Energy counter
- 6.3.3.8 Resettable energy counter
- 6.3.3.9 Fault history
Programming Honeywell • 15
Table 4. Parameters related with Modbus used through RTU
MONITORING VALUES
P5.7.3.2.1
Fieldbus protocol
status
13 1
0 = Init
1 = Stopped
2 = Operational
3 = Faulted
P5.7.3.2.2
Communication
status
0.0 99.999 0.0
0-99 Number of mes-
sages with errors
0-999 Number of mes-
sages without communi-
cation errors
P5.7.3.2.3 Illegal functions
0 See page 18.
P5.7.3.2.4
Illegal data
addresses
0 See page 18.
P5.7.3.2.5 Illegal data values
0 See page 18.
P5.7.3.2.6 Slave device busy
0 See page 18.
P5.7.3.2.7 Memory parity error
0 See page 18.
P5.7.3.2.8 Slave device failure
0 See page 18.
P5.7.3.2.9 Last fault response
0 See page 18.
P5.7.3.2.10 Control word hex
See page 25 and
page 26.
P5.7.3.2.11 Status word hex
See page 25 and
page 26.
Code Parameter Min Max Unit Default ID Description