User Guide
Table Of Contents
- 1. Safety
- 2. Modbus - general info
- 3. Modbus technical data
- 4. Modbus installation
- 5. Programming
- 5.2.1 Ethernet common settings (M5.8.1)
- 5.2.2 Modbus TCP settings (M5.8.2)
- 5.3.1 Modbus RTU Parameters
- 5.3.2 Modbus RTU monitoring values
- 5.4.1 Ethernet common settings
- 5.4.2 Modbus TCP settings
- 5.4.2.1 Common settings
- 5.4.3 Modbus TCP monitoring values
- 5.4.3.1 Connection 1
- 5.4.3.2 Connection 2
- 6.3.1 Coil registers
- 6.3.2 Input discrete registers
- 6.3.3 Holding and input registers
- 6.3.3.1 Drive Application ID’s
- 6.3.3.2 FB Process data IN
- 6.3.3.3 FB Process data OUT
- 6.3.3.4 ID map
- 6.3.3.5 Operation day counter
- 6.3.3.6 Resettable operation day counter
- 6.3.3.7 Energy counter
- 6.3.3.8 Resettable energy counter
- 6.3.3.9 Fault history
Honeywell • 28 Communications
Once the IDMap address range has been initialized with any parameter ID number, the param-
eter value can be read and written in the IDMap Read/Write address range address IDMap ad-
dress + 100.
If the IDMap table has not been initialized, all fields show the index '0'. If the it has been initial-
ized, the parameter ID's included in it are stored in the flash memory of the OPT-CI board.
Example of 32Bit IDMap
6.3.3.5
Operation day counter
Address Data
410601 Data included in parameter ID700
410602 Data included in parameter ID702
410603 Data included in parameter ID707
410604 Data included in parameter ID704
Table 23. Parameter Values in 16-bit IDMap Read/Write registers
Address Data
410701 Data High, parameter ID700
410702 Data Low, parameter ID700
410703 Data High, parameter ID702
410704 Data Low, parameter ID702
Table 24. Example of parameter values in 32-bit IDMap Read/Write registers
Address Register Purpose
40001 440001 Years
40002 440002 Days
40003 440003 Hours
40004 440004 Minutes
40005 440005 Seconds
Table 25. Operation day counter