User Guide

Honeywell • 3
TABLE OF CONTENTS
Document: DPD02021A
Version release date: 10.11.17
1. Safety ..................................................................................................................4
1.1 Danger ............................................................................................................................ 4
1.2 Warnings......................................................................................................................... 5
1.3 Earthing and earth fault protection.................................................................................. 6
2. BACnet - general info ........................................................................................7
3. BACnet technical data.......................................................................................8
3.1 BACnet MS/TP protocol.................................................................................................. 8
3.2 BACnet IP protocol ......................................................................................................... 8
3.3 ACD (Address Conflict Detection)................................................................................... 8
4. Programming .....................................................................................................9
4.1 BACnet MS/TP parameters and monitoring values ...................................................... 10
4.2 BACnet IP parameters and monitoring values.............................................................. 11
4.2.1 Ethernet common settings ............................................................................................ 11
4.2.2 BACnet IP settings........................................................................................................11
4.3 BACnet MS/TP parameter descriptions ........................................................................ 13
4.3.1 BACnet MS/TP Parameters .......................................................................................... 13
4.3.2 BACnet MS/TP monitoring values ................................................................................ 14
4.4 BACnet IP parameter descriptions................................................................................ 16
4.4.1 Ethernet common settings ............................................................................................ 16
4.4.2 BACnet IP settings........................................................................................................17
4.4.3 BACnet IP monitoring values ........................................................................................ 18
5. Installation........................................................................................................19
5.1 SmartVFD HVAC/SmartDrive HVAC AC drive ............................................................. 19
5.1.1 Prepare for use through Ethernet ................................................................................. 20
5.1.2 Prepare for use through RS485 .................................................................................... 22
6. Communications..............................................................................................26
6.1 Device Object................................................................................................................ 26
6.2 Object types and properties supported ......................................................................... 26
6.2.1 Binary Value Object ...................................................................................................... 27
6.2.2 Analogue Value Object ................................................................................................. 28
6.3 Control word bits ...........................................................................................................30
6.4 Status word bits ............................................................................................................30
6.5 COV functionality .......................................................................................................... 30
6.6 Processdata mapping in drive application .................................................................... 31
7. Fault tracing .....................................................................................................32
7.1 Typical fault conditions.................................................................................................. 32
7.2 Other fault conditions .................................................................................................... 33
8. Quick setup ......................................................................................................35
9. Annex - Protocol implementation conformance statement.........................36