User manual

3 - 20
Batch Mode Transmit Delay
Sometimes when accumulated scans are sent to the host system, the
transmission of those scans is too fast for the application to process. To
program a transmit delay between accumulated scans, scan one of the fol-
lowing delays.
Default = Off.
Note: In most cases, a short (250 ms (milliseconds)) delay is ideal,
however, longer delays may be programmed. Contact Technical
Support (page 13-2) for additional information.
Scanner Name
You may assign a name to each scanner you are using for identification pur-
poses. The default name is “Voyager.”
Perform the rename operation using either the bar codes on page 3-21, or by
sending the serial command :Voyager:BT_NAM
name . where name is the new
name for the scanner. If you wish to change the names of additional scanners,
link them to the base one at a time and repeat the :Voyager:BT_NAM
name .
command for each scanner.
* Batch Mode Transmit Delay Off
(No Delay)
Batch Mode Transmit Delay Short
(250 ms)
Batch Mode Transmit Delay Medium
(500 ms)
Batch Mode Transmit Delay Long
(1000 ms)