User manual

4 - 11
Manual Activation Laser Timeout - Button Settings
You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes when the button is held down, and after it
is released. Set the length (in milliseconds) for a timeout by scanning one
of the following bar codes, then setting the timeout (from 1-65535 millisec-
onds) by scanning digits from the Programming Chart, then scanning Save.
Default = Button Hold In-Stand 5000 ms, Button Hold Out-of-Stand 5000
ms, Button Release In or Out-of-Stand 0.
Laser Timeout - Button
Release In-Stand
Laser Timeout - Button Hold
In-Stand
Laser Timeout - Button
Release Out-of-Stand
Laser Timeout - Button Hold
Out-of-Stand