User manual

1 - 6
3. Make sure the cables are secured in the wireways in the bottom of the
base and that the base sits flat on a horizontal surface.
4. Plug the serial connector into the serial port on your computer.
Tighten the two screws to secure the connector to the port.
5. Once the scanner or base has been fully connected, power up the
computer.
This interface programs 9600 baud, 8 data bits, no parity, and 1 stop bit.
Connecting with RS485
A scanner or base can be connected for an IBM POS terminal interface.
1. Connect the appropriate interface cable to the device, then to the com-
puter.
Charge and
Communications
Base RS485
Connection: