User manual

2 - 24

Timeout Retries

This setting limits the number of Communication Timeout retries. If

the Timeout Retries is set to 0, the transmission is terminated after the

initial Communication Timeout. Scan the bar code below, then set the

number of retries (from 0-255) by scanning digits from the

Programming Chart, then scanning Save. (5 is the recommended set-

ting.)

Default = 0.

Communication Timeout Beeper

This selection programs the scanner to issue an error beep when a

communication timeout has occurred. The error beep sound is pro-

grammed using Number of Beeps – Error (page 4-4).

Default = On.

NAK Retries

This selection limits the number of NAK retries that can occur in ACK/NAK

mode. Scan the bar code below, then set the number of retries (from 0-

255) by scanning digits from the Programming Chart, then scanning Save.

(5 is the recommended setting.)

Default = 0, or disabled.

Timeout Retries

* On

NAK Retries