User manual

3 - 14
Automatic Batch Mode stores bar code data when the scanner is out of range
of the base. The data is automatically transmitted to the base once the scanner
is back in range. When the scanner’s buffer space is full, any bar codes
scanned generate an error tone. In order to scan bar codes again, the scanner
must be moved back into range of the base so data can be transmitted.
Inventory Batch Mode stores bar code data, whether or not you are in range of
the base. To transmit the stored data to the base, either place the scanner in
the base, or scan Transmit Inventory Records (page 3-19). When the scanner’s
buffer space is full, any bar codes scanned generate an error tone. In order to
scan bar codes again, the data must be transmitted to the base.
Default = Batch Mode Off.
Batch Mode Beep
When scanning in Batch Mode, the scanner beeps every time a bar code is
scanned. When Batch Mode Beep is On, you will also hear a click when
each bar code is sent to the host. If you do not want to hear these clicks,
scan Batch Mode Beep Off.
Default = Batch Mode Beep Off.
Batch Mode Quantity
When in Inventory Batch Mode (page 3-14), you may wish to transmit the
number of multiple bar codes scanned, rather than a single bar code multi-
ple times. For example, if you scan three bar codes called XYZ with Batch
Mode Quantity Off, when you transmit your data it will appear as XYZ
Automatic Batch Mode
* Batch Mode Off
Inventory Batch Mode
Batch Mode Beep On
* Batch Mode Beep Off