User manual

5 - 1

Healthcare Settings

The following settings have been developed to enhance scanning in a healthcare environment. These settings are only sup-

ported by the Xenon 1900h scanner and Xenon 1902h scanner and base. They allow you to set quickly configure streaming

presentation, and to set the scanner and base to quiet modes for scanning that does not disturb resting patients.

Quiet Operations - Combination Codes

The following combination codes program your Xenon healthcare scanner and base for silent or quiet settings using a single

programming code. If you wish to program some of these quiet settings individually, refer to Quiet Operations - LED and

Volume Settings, beginning on page 5-3.

Silent Mode with Flashing LED

Scan the following bar code to completely silence the Xenon 1900h scanner or Xenon 1902h scanner and base. The scan-

ner beep, base beep, base and scanner power up beep, and scanner linking sounds are all silenced. When a bar code is

scanned, the LED and aimer flash 5 times. Green indicates a good scan, red indicates a bad scan.

Silent Mode with Long LED

Scan the following bar code to completely silence the Xenon 1900h scanner or Xenon 1902h scanner and base. The scan-

ner beep, base beep, base and scanner power up beep, and scanner linking sounds are all silenced. When a bar code is

scanned, the LED and aimer remain solidly lit for 1 second. Green indicates a good scan, red indicates a bad scan.

Silent Mode with Flashing LED -

Cordless Scanner and Base

Silent Mode with Flashing LED -

Corded Scanner

Silent Mode with Long LED -

Cordless Scanner and Base

Silent Mode with Long LED -

Corded Scanner