User manual

5 - 5
LED Solid (No Flash)
Under normal operations, the scanner’s LED flashes once for a good read. You may set the LED to remain on for a length
of time after a good read instead of flashing. Default = LED Solid Off (Resume Flash).
If you have scanned a bar code and don’t want to wait for the LED to turn off, press the trigger a 2nd time and the LED turns
off. You can then scan the next bar code.
Paging Volume Control
Note: This setting is not supported by the Xenon 1900h scanner.
When you press the Page button on the base or Access Point, the scanners associated with that base or Access Point will
begin beeping in response. If you pull the trigger on a scanner that is beeping in response, or press the Page button on the
base or Access Point a second time, all associated scanners will stop beeping. The following settings set the paging vol-
ume, independent of the volume used when scanning bar codes. Default = Low.
* LED Solid Off
(Resume Flash)
LED Solid 1 Second
LED Solid 3 Seconds
LED Solid 5 Seconds
Paging Volume Off
* Paging Volume Low
Paging Volume Medium
Paging Volume High