Split Air Conditioner Manual
Table Of Contents
- Slide Number 1
- Slide Number 2
- Slide Number 3
- Slide Number 4
- Slide Number 5
- Slide Number 6
- Slide Number 7
- Slide Number 8
- Slide Number 9
- Slide Number 10
- Slide Number 11
- Slide Number 12
- Slide Number 13
- Slide Number 14
- Slide Number 15
- Slide Number 16
- Slide Number 17
- Slide Number 18
- Slide Number 19
- Slide Number 20
- Slide Number 21
- Slide Number 22
- Slide Number 23
- Slide Number 24
- Slide Number 25
- Slide Number 26
- Slide Number 27
- Slide Number 28
- Slide Number 29
- Slide Number 30
Emergency Operation
• If the remote controller is lost or broken, use the force switch button to operate
the air conditioner.
• If this button is pushed with the unit OFF, the air conditioner will operate in AUTO
mode.
• If this button is pushed with the unit ON, the air conditioner will stop running.
• The force switch is located on the right side of the unit and is in a tight space.
User may need a thin object such as a screwdriver to push the button.
Airflow Direction Adjustment
• Use up-down swing and left-right swing buttons on the remote controller to
adjust the airflow direction. Refer to the operation manual of the remote
controller for details.
NOTICES FOR USE
19
Test Operation Preparation
• Verify that all piping and connection cables are well connected.
• Confirm that the values at the gas side the liquid-side are fully open.
• Connect the power cord of the outdoor unit to an independent power socket.
• Install the batteries in the remote control.
Test Operation Method
1. Turn on the power and push the ON/OFF switch button of the remote controller
to start the air conditioner.
2. Select COOL, HEAT, SWING and other operation modes with the remote
controller and see if the operation is ok.
Specific Caution
1. Open the front panel of the indoor unit.
2. The connector can not touch the terminal board.
TEST OPERATION
Force Switch
(Front View – Open)