Split Air Conditioner Manual
Table Of Contents
- Slide Number 1
- Slide Number 2
- Slide Number 3
- Slide Number 4
- Slide Number 5
- Slide Number 6
- Slide Number 7
- Slide Number 8
- Slide Number 9
- Slide Number 10
- Slide Number 11
- Slide Number 12
- Slide Number 13
- Slide Number 14
- Slide Number 15
- Slide Number 16
- Slide Number 17
- Slide Number 18
- Slide Number 19
- Slide Number 20
- Slide Number 21
- Slide Number 22
- Slide Number 23
- Slide Number 24
- Slide Number 25
- Slide Number 26
- Slide Number 27
- Slide Number 28
- Slide Number 29
- Slide Number 30
6. TIMER
• With the unit ON, press this button to set OFF timer, with it OFF, press to set ON
timer.
• Press this button once, an “ON (OFF)” will flash. Press “
˄” or “˅” to set the number
of hours in which the unit will be turned ON/OFF, with an interval of 0.5 hour if less
than 10 hours, or 1 hour if longer than 10 hours, and a range of 0.5-24 hours.
• Press it again to confirm the setting, the “ON (OFF)” will stop flashing.
• If the timer button is not pressed longer than 10 seconds after the “ON (OFF)” start
flashing, the timer setting will be exited.
• If a timer setting is confirmed, pressing this button again will cancel it.
7. CLEAN
• Press this button with the unit OFF, the remote controller will display “CL” and the
unit will automatically clean dust off the evaporator and dry it. This will increase
the cooling and heating efficiency.
• The Clean function runs for approximately 30 minutes, if the unit is turned on with
the remote controller or this button is pressed again, the Clean function will be
deactivated.
• Each time the “
˄” is pressed, the temperature setting will increase by 1°F and each
time the “
˅” is pressed, it will decrease by 1°F. The temperature range is 60°F -
90°F.
NOTE: The temperature cannot be set in AUTO or FAN mode, thus these two
buttons are not functional.
9. TURBO
• Press this button only in COOL or HEAT mode to set TURBO on or off to speed the
cooling or heating.
• When TURBO is on, the air speed is HIGH.
• When TURBO is off, the air speed will restore to previous status.
10. MODE
• Press this button, you can select the running mode as follows: AUTO -> COOL ->
DRY -> HEAT -> FAN
22
8. ˄ OR ˅
REMOTE CONTROL FUNCTIONS