Fan Manual

DY-012 SERIES ASSEMBLY INSTRUCTIONS

NOTE: Remove all contents from the box being careful not to discard

the

manual and hardware needed for assembly. A phillips head screw

driver ( ) is required for assembly and is not included with the fan

purchase.

A. Base Assembly

• Gently turn the fan upside down.

• Place the power cord through the recessed channel located in the

center of the rear base assembly (Fig 1).

• Align the rear and front base assembly and firmly snap together

by pushing the 4 round extrusion into the adjacent circles of the

connecting pieces (Fig 2).

B. Securing the Tower Fan to the Base

• Using the 3 (M5 x 12) screws and phillips head screw driver ( )

secure the base into the bottom portion of the fan housing by

aligning the 3 screw holes on the base with the 3 screw holes on

the bottom of the fan housing (Fig 3).

• Gently pull any slack out of the power cord and place the cord

securely in the power cord

holding bracket (Fig. 4).

• Place the fan right side up.

Your fan is now ready

for use.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

DY-012 SERIES OPERATION INSTRUCTIONS

• Be sure your fan is in the

OFF position by pressing the

off button. (

)

• Place the fan on a level and

dry surface.

• Plug the power cord into a

polarized 120 Volt AC wall

outlet.

• To operate, press the

appropriate speed control

option: High (

), Medium ( ), or Low ( ) (Fig. 5).

• To activate or disengage the fan oscillation, press the oscillation button ( ) (Fig 6).

• To turn the fan OFF ( ) press the Off button once.

Fig. 5

Fig. 6