User Manual

3
A. BASE ASSEMBLY
• Align the front and back base pieces and gently push the halves until the pieces snap securely
together. (Fig 3).
B. SECURING THE TOWER FAN TO THE BASE
• At the base of the housing, remove the locking nut and set aside (Fig. 4)
• Carefully lift the fan housing (Fig. 5) and place the power cord through the center of the base.
• Lower the fan housing into the base (Fig. 6).
• Take the locking nut and thread the power cord through the locking nut and move the nut up
the power cord, (Fig.7). Attach the locking nut to the fan housing by turning clockwise until fully
tightened.
• The fan cord can exit either side of the base; choose which one is closer to your outlet. (Fig. 8)
• The back of this fan is intentionally closed. This allows the air intake and exit to happen at the front
grille. This aerodynamic cross-flow design harnesses the Turbo Force® power of your fan!
Note: DO NOT operate the tower fan unless it is in its proper, upright position.
• Be sure the fans are in the off position.
• Place your fan on a dry, level surface.
• Plug the power cord into a polarized 120-volt AC wall outlet, your fan is now ready to be used.
• To move the fan, turn the fans to OFF, unplug the unit from the wall outlet and pick the unit up
by the concealed handle located at the back of the top fan.
ASSEMBLY INSTRUCTIONS
OPERATION
Fig. 8
Fig. 3
Fig. 6
Fig. 7
Fig. 4 Fig. 5