Submittal Sheet

LP916A-C PNEUMATIC REMOTE BULB THERMOSTATS

75-5559

REPAIR

The only repair recommended for the LP916 is the

replacement of the plate and tube assembly, gaskets,

restriction plate, and filters with connector assembly and

gasket. Since February 1984, models have a different

connector assembly with a single gasket, these are included

in Repair Kit 14003113-002, as shown in Figure 8. All

available parts are listed in the PARTS AND ACCESSORIES

section.

EQUIPMENT REQUIRED

Gulmite Head Screw Wrench 316744-00021.

14003113-002 REPAIR KIT INSTALLATION

A Turn off system air and remove LP916 from system.

B Remove and save the three No. 8-32 x 7/16-in. pan

head screws from the connector assembly (Fig. 8) or

plate and tube assembly (Fig. 9 or 10).

C Lift off the connector assembly and gasket or plate and

tube assembly, restriction gasket, restriction plate, body

gasket, and two filters and discard.

D Place new gasket on body and align screw holes.

E Position the new connector assembly on gasket and

align screw holes. A 0.007 in. restriction may be used

for models with a 0.005 in. restriction with no effect on

operation except a slightly higher air consumption. If air

consumption is a problem, connector assembly with a

0.005 in. restriction may be ordered and substituted.

F Insert and tighten the three screws.

G Make operational check (See OPERATIONAL CHECK).

NOTE: For 14003113-001 Repair Kit follow directions on

package.

Fig. 8. Repair kit 14003113-002 (0.007 in. restriction

included in kit).

INDICATES 0.005 IN. RESTRICTION

INDICATES 0.007 IN. RESTRICTION

CONNECTOR

ASSEMBLY

GASKET

C8362