Full Product Manual

INSTALLATION INSTALLATIONSAFETY INFORMATION
PRE-INSTALLATION
WARNING: Read all safety precautions and installation instructions carefully before installing or
servicing this fixture. Failure to comply with these instructions could result in a potentially fatal electric
shock, fire, and/or property damage.
• To reduce the risk of electrical shock or other personal injury, ensure the power is turned OFF at the
fuse or breaker box before making any electrical connections.
• To reduce the risk of electrical shock, and to assure proper operation, this fixture must be adequately
grounded. To accomplish proper grounding, there must be a separate ground wire (bare copper)
contact between this fixture and the ground connection of your main power supply panel.
• Do not handle any energized fixture or attempt to energize any fixture with wet hands or while
standing on a wet or damp surface or in water.
• It is recommended that a qualified electrician perform all wiring. This fixture must be wired in
accordance with all national and local electrical codes.
• This fixture is intended to be used for general outdoor lighting, in wet locations, and should be
mounted at least 8 ft. above the ground.
• Assure that the fixture is mounted onto a structurally sound surface that will support the fixture.
• This fixture is designed for use in a 120VAC, 60Hz fused circuit. Do not use on a dimming circuit.
• Do not look into the lights.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED
PLANNING INSTALLATION
• Turn off the electrical power at the fuse or circuit breaker box before installing or servicing any
part of this fixture.
• Carefully remove the fixture from the carton and check that all parts are included. Be careful
not to misplace any of the screws or parts needed for installing the fixture.
TESTING THE LIGHT FIXTURE
• Turn on the circuit breaker and light switch.
• To test operationduring daylight, cover the photocell.
NOTE:When first turned on wait about 1 minute for the circuitry to calibrate.
HARDWARE INCLUDED (note: some parts may be pre-assembled)
TOOLS REQUIRED (Not Included)
PARTS
A - Light fixture
B - Mounting Bracket
CAUTION: Before beginning installation turn off the circuit breaker and light switch.
• This fixture is suitable for wall or eave mount only. Not suitable for ground mount installation.
IMPORTANT: Do not use with dimmers or timers.
• Junction box is required for the assembly.
• For best performance, mount the fixture 8-12 feet above the ground.
NOTE: For proper connection, place the wire nut over wires and twist clockwise until tight.
INSTALLING THE MOUNTING BRACKET
Junction Box
INSTALLING THE MOUNTING BRACKET
1. Thread the two screws (AA) through the mounting bracket (B).
2. Attach mounting bracket (B) with screws to junction box and tighten so bracket is firmly in place.
MOUNTING THE FIXTURE
1. Line up the holes on the light fixture (A) and the mounting bracket (B).
2. Place the screws (BB) through washers (DD) into the light fixture (A) and align with holes on
mounting bracket (B). Tighten until firmly in place.
3. Apply silicone caulk (not included) around the edges of the cover plate to provide a watertight
seal from rain and moisture.
CONNECTING THE WIRES
1. Connect the house ground wire to the fixture ground (yellow/green) wire using the wire nut (CC).
2. Connect the fixture black wire to the house black wire and the fixture white wire to the house
white wire using the wire nuts (CC).
AA:
Phillips Head Screws (2)
8-32UNC×20
BB:
Phillips Head Screws (2)
M4×12 (9mm head)
DD:
Washer (2)
8 mm x 4.5 mm x 2 mm
CC:
Wire Nut (3)
P2 10 mm x 17.2 mm