User`s guide

37
Audible Indicators
When in operation the MS2420/MS2430 provides audible feedback that indicates the status of the unit and the
current scan. Eight settings are available for the tone of the beep (normal, six alternate tones and no tone)
plus three volume settings. To change the tone or volume, refer to the Changing the Beeper Tone & Volume
section of this manual.
One Beep
When the scanner first receives power the blue LED will flash then the blue LED will stay on and the scanner
will beep once. The scanner is now ready to scan.
When the scanner successfully reads a bar code, the blue LED will flash and the scanner beeps once (if
configured to do so). If the scanner does not beep once and the blue light does not flash, then the bar code
has not been successfully read.
Razzberry Tone
This is a failure indicator. Refer to failure modes on page 39.
Three Beeps - during operation
When placing the scanner in configuration mode, the blue LED will flash while the scanner simultaneously
beeps three times. The blue LED will continue to flash until the unit exits configuration mode. Upon exiting
configuration mode, the scanner will beep three times and the blue LED will stop flashing.
When configured, three beeps can also indicate a communications timeout during normal scanning mode.
When using one-code-configuring, the scanner will beep three times (the current selected tone), followed by a
short pause, a high tone and a low tone. This tells the user that the single configuration bar code has
successfully configured the scanner.
Three Beeps - on power up
This is a failure indicator. Refer to failure modes on page 39.