Install Instructions

ManualsBrandsHoneywell ManualsDamper actuatorsNon-Spring Return Floating Actuator, 44 lb-in

PRODUCT DATA

63-2632

EN0B-0544GE51 R0805

® U.S. Registered Trademark

N05, N10 SERIES

NON-SPRING RETURN DIRECT-COUPLED DAMPER ACTUATORS FOR

FLOATING AND TWO-POSITION CONTROL

GENERAL

This non-spring return direct-coupled damper actuator

provides floating and two-position control for:

• air dampers,

• VAV units,

• air handlers,

• ventilation flaps,

• louvers, and

• reliable control for air damper applications with up to 10 sq

ft / 44 lb-in. (5 Nm) and 20 sq ft / 88 lb-in. (10 Nm) (seal-

less damper blades; air friction-dependent).

FEATURES

• Declutch for manual adjustment

• Adjustable mechanical end limits

• Removable access cover for direct wiring

• Mountable in any orientation

• Rotation direction and service/OFF switch

SPECIFICATIONS

Supply voltage

MN6105/MN6110 24 Vac/dc -15%/+20%, 50/60 Hz

Nominal voltage

MN6105/MN6110 24 Vac/dc, 50/60 Hz

All values stated hereinafter apply to operation under

nominal voltage conditions.

Power consumption

MN6105/MN6110 5 VA / 2 W

Ambient limits

Ambient operating limits -5...+140 °F (20...+60 °C)

Ambient storage limits -22...+176 °F (-30...+80 °C)

Relative humidity 5...95%, non-condensing

Safety

Protection standard IP54

Protection class II as per EN 60730-1

Overvoltage category II

Lifetime

Full strokes 60000

Repositions 1.5 million

Mounting

Round damper shaft 3/8 in…5/8 in.

Square damper shaft 1/4 in…1/2 in.; 45° steps

Shaft length min. 1-5/8 in.

End switches (when included)

Rating Class II

Triggering points 5° / 85°

Torque rating 44 lb-in. (5Nm) / 88 lb-in. (10 Nm)

Runtime for 90°

MN6105 90 sec (dc / 60 Hz ac)

MN6110 90 sec (dc / 50 Hz ac)

Rotation stroke 95° +

3°

Dimensions see “Dimensions” on page 6

Weight (without cables) 1 lbs.

Noise rating 35 dB(A) max. at 1 m

Summary of content (8 pages)

PAGE 1
N05, N10 SERIES NON-SPRING RETURN DIRECT-COUPLED DAMPER ACTUATORS FOR FLOATING AND TWO-POSITION CONTROL PRODUCT DATA SPECIFICATIONS Supply voltage MN6105/MN6110 24 Vac/dc -15%/+20%, 50/60 Hz Nominal voltage MN6105/MN6110 24 Vac/dc, 50/60 Hz All values stated hereinafter apply to operation under nominal voltage conditions.
PAGE 2
N05, N10 SERIES DAMPER ACTUATORS FOR FLOATING/2-POSITION CONTROL PRODUCT IDENTIFICATION SYSTEM Legend for Fig. 1: M—Electrical Motor N—Fail Safe Function (Non-Spring Return) 61—24V Floating Control 75—24V Modulating Control 05—44 lb-in. (5 Nm) 10—88 lb-in.
PAGE 3
N05, N10 SERIES DAMPER ACTUATORS FOR FLOATING/2-POSITION CONTROL Floating/2-Position Run Mode Limitation of Rotation Stroke If the function selection switch has been set to one of the two floating/2-position control settings—and if the actuator is wired correspondingly (see Fig. 7, Fig. 8, and Fig. 9)—then as soon as operating power is applied, the shaft adapter will run according to the control signals applied.
PAGE 4
N05, N10 SERIES DAMPER ACTUATORS FOR FLOATING/2-POSITION CONTROL INSTALLATION WIRING CAUTION CAUTION To avoid personal injury (electrical shock) and to prevent equipment damage, before installation, you must remove power. To avoid personal injury (electrical shock) and to prevent equipment damage, before wiring, you must remove power. Access Cover These actuators are designed for single-point mounting.
PAGE 5
N05, N10 SERIES DAMPER ACTUATORS FOR FLOATING/2-POSITION CONTROL NOTE: Both internal end switches must be connected to the same power source. MN6105, MN6110 TWO-POSITION: DIR Tables 2 and 3 summarize the information presented in the preceding wiring diagrams. ACTUATOR 1 1 V 2 24 VAC 2 Table 2. Signals at terminals for MN6105/MN6110 3 terminal 4 5 1 LINE VOLTAGE POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED. 2 24 VDC SUPPLY ACCEPTABLE.
PAGE 6
N05, N10 SERIES DAMPER ACTUATORS FOR FLOATING/2-POSITION CONTROL DIMENSIONS 1-5/8 (41) 5-9/32 (134) 3-11/32 (85) 4-1/4 (108) Dir Service/Off Rev 2-7/16 (62) 2-19/32 (66) Fig. 10. Dimensions (in in.
PAGE 7
N05, N10 SERIES DAMPER ACTUATORS FOR FLOATING/2-POSITION CONTROL 7 63-2632 EN0B-0544GE51 R0805
PAGE 8
N05, N10 SERIES DAMPER ACTUATORS FOR FLOATING/2-POSITION CONTROL Automation and Control Solutions Honeywell International Inc. Honeywell Limited-Honeywell Limitée 1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55422 Scarborough, Ontario M1V 4Z9 customer.honeywell.com ® U.S. Registered Trademark © 2005 Honeywell International Inc. 63-2632 EN0B-0544GE51 R0805 A.A. Rev.