Portable Air Conditioner User Manual Read and save these instructions before use Email: info@jmatek.com Web: www.jmatek.
THANK YOU Congratulations on your purchase of this versatile Honeywell Portable Air Conditioner. USER TIPS Honeywell Portable Air Conditioners are ideal for spot cooling. The compressor, condenser and evaporator are housed in a compact unit. The air is filtered, dehumidified and cooled while a flexible air outlet hose sends heat outside. The air conditioner includes a window venting kit. No permanent installation is needed.
SAFETY READ AND SAVE THESE INSTRUCTIONS Improper handling can cause serious damage to the appliance. WARNING: • DO NOT operate the unit with a damaged plug or loose wall outlet. If the power cord is damaged, it must be replaced by the manufacturer or an authorized service agent. • DO NOT cover the air intake and exhaust when in use. • This appliance is not intended for use by children. Children should be supervised and should not play on or around the appliance. • DO NOT place objects on or sit on the unit.
INSTALLATION Installation Kit: 1. 2. 3. 4. 5. 1 2 Window Bracket Kit............................. 1 Set Window Bracket Panel Adapter........... 1 Piece Plastic Pin............................................ 2 Pieces Hose Connector.................................. 1 Piece Plastic Hose........................................ 1 Piece 4 3 x1 x2 x1 5 x1 Installation Steps: x1 1. Install the plastic hose with window bracket adapter and hose connector on both sides. Ensure proper fit on both ends.
INSTALLATION (CONTINUED) NOTE: 1. The supplied exhaust hose can be extended from 30 cm to 120 cm / 12 inches to 47 inches. 2. Do not bend (to the extent shown below) the exhaust hose. A bent hose will block exhaust air and cause the unit to malfunction or shut-off. NOT RECOMMENDED • • MIN. 36 cm / 14” MAX. 102 cm / 40” 50 cm / 20” RECOMMENDED The length of the exhaust hose is determined by the product specifications. Do not replace or lengthen it as this could cause the unit to malfunction.
USE & OPERATION (CONTINUED) FUNCTION BUTTONS (CONTINUED) • Dehumidifying Mode Air is dehumidified as it passes through the unit, without being in full cooling mode. If room temperature is higher than 25°C (77°F) fan speed can be adjusted; otherwise fan speed is preset to LOW. Note: If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose and let the warm air return in the room. Continuous drainage is then necessary and more efficient (refer to Continuous Draining).
USE & OPERATION (CONTINUED) REMOTE CONTROL The functions work the same as the portable air conditioner's Control Touch Screen Panel. Control Panel. All key functions can be accessed from the remote control. Power Control Temperature / Timer Set ON / OFF • Used for adjusting the timer and temperature. • When ▼ or ▲ key is pressed in cool mode, the set temperature is displayed and may be adjusted. After 10 seconds the display will revert back to room temperature.
CLEANING & MAINTENANCE Air filter Appliance Maintenance: 1. Turn off the appliance before disconnecting the power supply. 2. Always clean the appliance with a soft dry cloth. Air Filter Maintenance: The air filter should be cleaned every two weeks. Clean it as follows: 1. Turn off the appliance and remove the air filter . 2. Rinse it in lukewarm water. After cleaning, dry in a shaded and cool place, then reinstall.
WATER CONDENSATION DRAINAGE WATER CONDENSATION DRAINAGE When there is excess water condensation inside the unit, the air conditioner stops running and shows a warning light. This warning light indicates that the water condensation needs to be drained using the following procedures: Manual Draining for AC & Dehumidifier Mode Water may need to be drained in high humidity areas. 1. Unplug the unit from power source. 2. Place a shallow pan under the lower drain plug. See diagram. 3. Remove the lower drain plug.
TROUBLESHOOTING GUIDE The following troubleshooting guide addresses the most common problems. If problems persist, call customer service. Unplug and disconnect the appliance from the power source before attempting to troubleshoot. PROBLEM The air conditioning unit does not start Runs a short while only POSSIBLE CAUSE • No electricity. • Batteries in the remote control need to be replaced. • The power cord is not properly plugged in. • The safety LCDI plug has tripped.
JMATEK North America LLC Mahwah, New Jersey 07495 USA Phone: 1-800-474-2147 Email: usinfo@jmatek.com Web: www.jmatek.com © 2015 JMATEK Limited. All rights reserved. The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to these products. These products are manufactured by JMATEK Limited.
