User manual

6 - 43
QR Code Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description (page 6-1) for additional
information. Minimum and Maximum lengths = 1-7089. Minimum Default = 1, Maximum Default = 7089.
QR Code Append
This function allows the scanner to append the data from several QR Code bar codes together before transmitting them to
the host computer. When the scanner encounters an QR Code bar code with the append trigger character(s), it buffers the
number of QR Code bar codes determined by information encoded in those bar codes. Once the proper number of codes is
reached, the data is output in the order specified in the bar codes. There are 3 ways to scan appended QR Code:
• One scan—Pull the trigger one time and all appended QR Codes in the same image are decoded
• Swipe—Pull and hold down the trigger and scan all appended QR Codes while keeping the trigger pressed. The scanner
emits short beeps for each partial QR Code that is scanned and buffered. One long beep is emitted after the last QR Code
is scanned and the data is complete. Not compatible with Presentation mode.
• Point and shoot—Pull the trigger one time for each image. The scanner emits a short beep for each partial QR Code that
is scanned and buffered. One long beep is emitted after the last QR Code is scanned and the data is complete. Not
compatible with Presentation mode.
Default = One Scan.
Minimum Message Length
Maximum Message Length
* One Scan
Swipe
Point and Shoot
Off