User manual

10 - 10
Output Sequence Editor Enter Sequence SEQBLK 3-17
Default Sequence SEQDFT 3-17
Partial Sequence Transmit Partial Sequence SEQTTS1 3-18
*Discard Partial Sequence SEQTTS0 3-18
Require Output Sequence Required SEQ_EN2 3-18
On/Not Required SEQ_EN1 3-18
*Off SEQ_EN0 3-18
Multiple Symbols On SHOTGN1 3-18
*Off SHOTGN0 3-18
No Read On SHWNRD1 3-19
*Off SHWNRD0 3-19
Video Reverse Video Reverse Only VIDREV1 3-19
Video Reverse and Standard Bar Codes VIDREV2 3-19
*Video Reverse Off VIDREV0 3-19
Working Orientation *Upright ROTATN0 3-20
Vertical, Bottom to Top (Rotate CCW 90°) ROTATN1 3-20
Upside Down ROTATN2 3-20
Vertical, Top to Bottom (Rotate CW 90°) ROTATN3 3-20
Prefix/Suffix Selections
Add CR Suffix to All Symbologies VSUFCR 4-2
Prefix Add Prefix PREBK2## 4-2
Clear One Prefix PRECL2 4-2
Clear All Prefixes PRECA2 4-2
Suffix Add Suffix SUFBK2## 4-2
Clear One Suffix SUFCL2 4-2
Clear All Suffixes SUFCA2 4-2
Function Code Transmit *Enable RMVFNC0 4-3
Disable RMVFNC1 4-3
Intercharacter Delay Range 0 - 1000 (5ms increments) DLYCHR## 4-3
User Specified
Intercharacter Delay
Delay Length
0 - 1000 (5ms increments)
DLYCRX## 4-4
Character to Trigger Delay DLY_XX## 4-4
Interfunction Delay Range 0 - 1000 (5ms increments) DLYFNC## 4-4
Intermessage Delay Range 0 - 1000 (5ms increments) DLYMSG## 4-4
Data Formatter Selections
Data Format Editor *Default Data Format (None) DFMDF3 5-1
Enter Data Format DFMBK3## 5-2
Clear One Data Format DFMCL3 5-2
Clear All Data Formats DFMCA3 5-2
Data Formatter Data Formatter Off DFM_EN0 5-11
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page