User manual

6 - 11

Code 93 Code Page

Code pages define the mapping of character codes to characters. If the data received does not display with the proper

characters, it may be because the bar code being scanned was created using a code page that is different from the one the

host program is expecting. If this is the case, scan the bar code below, select the code page with which the bar codes were

created (see ISO 2022/ISO 646 Character Replacements on page A-7), and scan the value and the Save bar code from

the Programming Chart on the inside the back cover of this manual. The data characters should then appear properly.

Straight 2 of 5 Industrial (three-bar start/stop)

Straight 2 of 5 Industrial On/Off

Straight 2 of 5 Industrial Message Length

Scan the bar codes below to change the message length. Refer to Message Length Description (page 6-1) for additional

information. Minimum and Maximum lengths = 1-48. Minimum Default = 4, Maximum Default = 48.

Code 93 Code Page

* Off

Minimum Message Length

Maximum Message Length