User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 25
3. Turn the platen roller release lever clockwise and slide the platen roller away
from the printer.
4. Feed the antenna cable through the round cutout from the electronics side of
the printer. Connect the antenna cable to the antenna cable jack on the RFID
antenna.
5. Insert the RFID antenna into the media guide assembly. Make sure that both
the antenna cable and media guide wires are not pinched between the media