User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 29
Applicator Interface Board
This section describes how to physically install and configure the Applicator inter-
face board in the PM45 and PM45c printers.
Printer Firmware
The printer must be fitted with Honeywell Fingerprint v10.18.00.0015 (or later).
Note: The kit supports only Fingerprint, Direct Protocol, and ZSim.
Out of the Box
The Applicator Interface Board installed kit includes:
• One Applicator Interface Board
• One power cable
• Two USB cables
• One spacer screw
• One 3x8mm Torx screw
• Two 4x8mm Torx screws
The only tools required for installation are the #T10 and #T20 Torx screwdrivers.