User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 47
Display Messages
These messages appear in the printer display under certain conditions when a
PRINTFEED command is run.
Cause:
Running the PORTOUT.DATAREADY ON|OFF or
PORTIN.<SIGNAL> GOSUB XXX commands when the printer
is using Direct Protocol.
Error Number:
90
EAPPERR1
Message:
Applicator Error 1.
Cause:
AppErr1 in signal detected.
Result:
Activates event in System Health Monitor (SHM).
Error Number:
1340
EAPPERR2
Message:
Applicator Error 2.
Cause:
AppErr2 in signal detected.
Result:
Activates event in System Health Monitor (SHM).
Error Number:
1341
EAPPERR3
Message:
Applicator Error 3.
Cause:
AppErr3 in signal detected.
Result:
Activates event in System Health Monitor (SHM).
Error Number:
1342
ERTWINEXT
Message:
RTW Extenal Error.
Cause:
RTWExternal in signal detected.
Result:
Activates event in System Health Monitor (SHM).
Error Number:
1343
ENODATAREADY
Message:
Dataready not enabled.
Cause:
Application sent a PRINTFEED in Fingerprint when the
applicator port is enabled, the style is set to I-Style or Z-Style,
and the dataready signal is not enabled.
Result:
Terminates the printfeed command without printing a label.
Error Number:
1344