User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
68 PM45 and PM45c Accessory User Guide
1. Remove the media cover. (See page 2)
2. Remove the electronics cover. (See page 4)
3. Remove the Phillips screw that attaches the media hanger to the printer and
then slide the hanger down and away from the printer.
4. From the electronics side, push the media sensor cover out of the printer base
and remove it.