User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 19
IEEE 1284 Parallel Board
This section describe how to install the IEEE1284 Parallel port interface board and
the connector configuration.
Out of the Box
• One IEEE 1284 Parallel Port Board
• One USB cable
The only tools required for installation are the #T10 and #T20 Torx screwdrivers.
Installation
Follow the procedure to physically install the IEEE1284 Parallel Port Board in the
PM45/PM45c printer.
Warning: The installation described in this section must be only
performed by an authorized service technician. Honeywell
assumes no responsibility for personal injury or damage to the
equipment if the installation is performed by an unauthorized
person.
Caution: Follow standard ESD guidelines to avoid damaging the
equipment.
Caution: Before you begin, turn off the printer and disconnect the power
cord and communication cables.